Table of Contents
Advertisement
1
P
LEASE OBSERVE THE FOLLOWING
1.2 S
AFETY INSTRUCTIONS
Machine operating safety
1.2.2
Installation, maintenance
WARNING!
Improper usage of the machine can lead to
accidents, material damage and loss of pro-
duction!
When installing the labeller, check for
visible shipment damage. Immediately in-
form Avery Dennison of any damage.
When installing the machine on a support
stand, make sure that it can not tip over.
Only put the labeller into operation if it is
in flawless condition.
Only perform alterations or conversions
to the labeller with the consent of Avery
Dennison's customer service.
Only use original replacement parts.
WARNING!
Danger of body part trapping and pinching at
the dispensing edge due to products moving
in the conveyor direction!
Take appropriate measures to prevent
personnel from reaching between a prod-
uct and the dispensing edge; e.g. install a
protective guard or shield.
WARNING!
Before starting up the machine:
Carry out test runs using the task-specif-
ic settings under near production condi-
tions.
Only put the machine into operation after
at least one successful test run has been
completed.
After all servicing or repair work
WARNING!
Risk of an accident due to moving or loose
parts!
Re-install all covers and safety equip-
ment.
Check for firm seating of all screw con-
nections that were loosened during the
work.
Remove all tools and other aids used dur-
ing service and repair from the working
area of the labeller.
Verify flawless functioning of all safety
equipment.
WARNING!
This unit operates at mains voltage! Coming
into contact with electrically live compo-
nents can cause potentially lethal electrical
shocks and burns.
After assembling, check the printer ac-
cording to the regulations relevant in
your country.
10
ALS
104
Advertisement
Table of Contents
