Machine Operating Safety; Installation, Maintenance; Protection Measures In Applicator Mode; After All Servicing Or Repair Work - Avery Dennison ALS 204 Installation Manual

1 P
LEASE OBSERVE THE FOLLOWING
1.2 S
AFETY INSTRUCTIONS

Machine operating safety

1.2.2

Installation, maintenance

WARNING!
Improper usage of the machine can lead to
accidents, material damage and loss of pro-
duction!
When installing the labeller, check for

visible shipment damage. Immediately in-
form Avery Dennison of any damage.
When installing the machine on a support

stand, make sure that it can not tip over.
Only put the labeller into operation if it is

in flawless condition.
Only perform alterations or conversions

to the labeller with the consent of Avery
Dennison's customer service.
Only use original replacement parts.

WARNING!
Danger of body part trapping and pinching at
the dispensing edge due to products moving
in the conveyor direction!
Take appropriate measures to prevent

personnel from reaching between a pro-
duct and the dispensing edge; e.g. install
a protective guard or shield.
WARNING!
Before starting up the machine:
Carry out test runs using the task-speci-

fic settings under near production condi-
tions.
Only put the machine into operation after

at least one successful test run has been
completed.

Protection measures in applicator mode

WARNING!
Danger of crushing between dispenser edge
and applicator pressure plate due to
applicator movement!
Prevent personnel from reaching bet-

ween dispensing edge and applicator by
installing higher-level protective equip-
1
ment .
Movable, locked, separating protective equipment (EN ISO
1)
12100-1, 3.25.4)

After all servicing or repair work

WARNING!
Risk of an accident due to moving or loose
parts!
Re-install all covers and safety equip-

ment.
Check for firm seating of all screw con-

nections that were loosened during the
work.
Remove all tools and other aids used du-

ring service and repair from the working
area of the labeller.
Verify flawless functioning of all safety

equipment.
WARNING!
This unit operates at mains voltage! Coming
into contact with electrically live compo-
nents can cause potentially lethal electrical
shocks and burns.
After assembling, check the printer ac-

cording to the regulations relevant in
your country.
10
ALS
20X
256