Rear Wheels; Wheel Hub - wsm ME8200 Workshop Manual

ME8200, ME9000, WSM

(2) Rear Wheels

Rear tread width can be adjusted as shown with the standard equipped tires.
To change the tread width.
1. Remove the wheel rim and / or disk mounting bolts.
2. Change the position of the rim and / or disk (right and left) to the desired position, and tighten the bolts.
CAUTION
• When working on slopes or working with trailer, set the wheel tread as wide as practical for the job for
maximum stability.
IMPORTANT
• Always attach tires as shown in the drawings above.
• If not attached as illustrated, transmission parts may be damaged.
• Do not use tires larger than specified.
• When re-fitting or adjusting a wheel, tighten the nuts to the following torques then recheck after driving
the tractor 200 m (200 yards) and thereafter daily check service.
ME8200
18.4R30
ME9000
ME9000 16.9R34
(1) Rear Wheel Disc

[3] WHEEL HUB

1575 mm
(62.00 in.)
1580 mm
(62.20 in.)
(2) Rear Wheel Rim
Screw circle diameter (A)
Number of screws
Screws
Hub pilot diameter (B)
1665 mm
(61.61 in.)
1665 mm
(61.61 in.)
(A) Tread
G-67
1780 mm 1870 mm
(70.08 in.) (73.62 in.)
1785 mm 1870 mm
(70.28 in.) (73.62 in.)
Front wheel hub Rear wheel hub
203.2 mm (8 in.) 203.2 mm (8 in.)
6
M16 x 1.5 M16 x 1.5
152.4 mm (6 in.) 152.4 mm (6 in.)
KiSC issued 03, 2007 A
G GENERAL
W10580340
8
W1043392