1St Shaft, 2Nd Shaft And 3Rd Shaft - wsm M8540NARROW Workshop Manual

M8540Narrow, M9540Narrow, WSM
PTO Shaft and Bearing Holder
1. Pull out the PTO shaft (1) with 33T gear (3).
2. Remove the bearing holder mounting screws.
3. Screw in a M12 × 1.25 mm screw (5) into threaded hole (a) to
remove the bearing holder (2).
4. Remove the bearing holder (2) with 35T gear (4).
(1) PTO Shaft
(2) Bearing Holder
(3) 33T Gear
(4) 35T Gear
(5) M12 ×1.25 mm Screw

1st Shaft, 2nd Shaft and 3rd Shaft

1. Slowly pull out the three shafts with gears together.
2. Take out the three shafts from clutch housing case.
IMPORTANT
• Do not fall down the shaft when removing the shafts with
gears.
• Do not tap the bearing stop part "a" of clutch housing case,
it cause break a part of clutch housing case. Be sure to tap
at the inner race of bearing (4) or 2nd shaft when remove
the 2nd shaft assembly (2).
• For easily assemble, stand the clutch housing case and
assemble the 1st shaft assembly (1), 2nd shaft assembly (2)
and 3rd shaft assembly at same time.
(1) 1st Shaft Assembly
(2) 2nd Shaft Assembly
(3) 3rd Shaft Assembly
(4) Bearing
N3-S17
TRANSMISSION
(a) Threaded Hole (M12 × P1.25 mm)
9Y1210236TRS0025US0
a: Bearing Stop Part
9Y1210236TRS0026US0
KiSC issued 07, 2013 A