Table of Contents
Advertisement
Unscrew the four fixing screws of the handlebar U bolt.
Remove the handlebar with the U bolt.
During the reassembly, you should pay
attention to the right positioning of the U
bolt in regard to the handlebar. This is made
using a pin that you have to insert in the
right seating of the handlebar.
Torque wrench of the U bolt handlebar fixing
screws: 20 N•m
DISASSEMBLING HEADLIGHT SUPPORT
Unscrew the three fixing screws and remove the sup-
port.
For reassembling, perform the following operations:
- Apply the breakthread "Loctite 243" on the threaded
part of the three fixing screws.
- Position the headlight support under the steering
base and insert the three fixing
washers without tightening.
- Gently push the headlamp support towards the rear
of the motorcycle as far as the headlamp support slots
will permit.
- Tighten the fixing screws.
Torque wrench of the headlight
support screws: 8 ÷ 10 Nm
Specific product: LOCTITE 243
Bodywork
screws with the
- 7 -
20 N•m
8÷10 N•m
C
Advertisement
Table of Contents
