MV Agusta BRUTALE 750 S Workshop Manual page 288

For reassembly, insert the pinion wheel with the chain
already attached.
Insert a new washer on to the threaded cam shaft, tigh-
ten the nut and strongly tighten the prescribed coupling
using an average-strength threadlock fluid.
Hammer the new washer down onto the two opposite
faces of the hexagon.
Chain pinion wheel nut torque pressure:
140 N•m
Recommended thread-locking fluid:
Loctite 243
Reassemble the pinion wheel cover after having clea-
F
ned the support base.
Screw in the four screws lightly and proceed with the
tightening, screwing down respectively on the three
screws M8 (1) and on the screw M6 (2).
Replace the rubber bands and reinsert the electrical
connector.
Torque pressure (M8 Screws):
Torque pressure (M6 Screws):
Suspension and wheels
25 N•m
8 N•m
- 74 -
140 N•m
1
2
8 N•m
25 N•m