Table of Contents
Advertisement
Front disc assembly
Thoroughly clean the contact surfaces of the discs and
the wheel.
Accurately grease all relative surfaces of the disc befo-
re reassembling.
Apply thread-locking fluid to the five fixing screws of
the disc.
Recommended thread-locking fluid:
Loctite 243
Screw in the screws lightly, proceeding in a star-like
mode.
Continuing in a star-like mode, tighten the screws to
the prescribed torque pressures.
Front brake disc screw torque pressure:
23 ÷ 25 N•m
Be careful to reassemble the discs in the original posi-
tions (it is advisable to mark them by applying an adhe-
sive label).
This operation is important so that a good
contact between the brake discs and the
relative pads.
Reassemble the wheel pin and the wheel as described
in chapter F "Suspensions and wheels".
Brakes
23÷25 N•m
- 25 -
H
Advertisement
Table of Contents
