Table of Contents
Advertisement
Adjust➝
At the first 1000 kilometres and then
every 6000 kilometres
To adjust the chain tension, proceed as follows:
Slightly loosen the 2 screws of the back wheel hub until
they can freely turn.
Using the special spanner as indicated in the figure,
move the eccentric adjuster nut backwards or forwards
respectively slackening or tightening the chain, until
the correct play is reached (as described previously).
Successively tighten the screws of the rear wheel hub
to the torque pressure indicated as follows.
N.B.
Tighten the screws to the specified torque
in several steps and in an alternate pattern.
Rear hub eccentric adjuster screw torque
pressure: 28 ÷ 32 N·m
After tightening the screws of the rear wheel hub,
recheck the chain tension so that any eventual varia-
tions can be found. If the tension of the chain is varied
in respect of the adjustment before tightening the rear
wheel hub, then repeat the adjustment procedure of
the transmission chain.
When adjusting the tension of the chain the
motorcycle set up adjustment must be car-
ried out beforehand. See "Motorcycle set up
adjustment" described in chapter F "SUS-
PENSIONS AND WHEELS".
Maintenance
- 79 -
28÷32 N•m
B
Advertisement
Table of Contents
