Reassembly Rocker Arm Assembly; Assembly Rear Shock Absorber - MV Agusta BRUTALE 750 S Workshop Manual

When reassembling, it is necessary to apply a special
product to the three screws. Lightly screw them in.
Tighten the central screw first and then the other two to
the prescribed torque pressure.
Special product Loctite 243
Torque pressure: 40 ÷ 44 N•m

Reassembly rocker arm assembly

Reassemble the rocker arm assembly after having
cleaned and greased the seat of the special screw
situated on the swingarm.
Screw in the screw without tightening it.
Recommended grease : Agip Grease 30

Assembly rear shock absorber

Accurately clean all parts. Grease the screws with Agip
Grease 30 before reassembly.
Insert the shock absorber from above and lightly screw
in the lower screw of the shock absorber.
Centralise the rocker arm assembly and replace the
pin. Screw on the nut of the pin without tightening it.
Insert the shock absorber into the rocker arm assem-
bly and lightly screw in the screw.
Lower the motorcycle to the ground, remove
the lift and safety straps.
This operation is necessary to recover the
play between the shock absorber/rocker arm
assembly/swingarm.
Recommended grease: Agip Grease 30
Suspension and wheels
- 41 -
40÷44 N•m
F