Table of Contents
Advertisement
For assembling repeat the same phases described for
disassembling the components, but reversing the
order.
Reassemble the following components in order:
- Air filter compartment
- Fuel tank
Start the engine for a few seconds. Let it cool and
then re-check the level of the cooling liquid inside the
expansion tank.
It must reach the line shown in the figure, keeping sli-
ghtly over the MIN reference.
If the level is lower than the line shown, reset it adding
new liquid from the filling cap; restart the engine until
the temperature is reached and wait for the fan comes
into operation at least twice. Shut off the engine and
wait for the temperature falls; finally perform the defini-
tive check of the coolant level.
L
Complete the motorcycle assembly.
Cooling system and lubrication system
- 32 -
Advertisement
Table of Contents
