Table of Contents
Advertisement
Remove the front stand and rest the front wheel on the
ground.
While pulling the front brake lever, push down on the
front suspension two or three times to allow the right-
hand fork rod to position itself properly.
Tighten the right (4) and left (5) fork foot screws.
F
N.B.
Tighten the screws to the specified torque
in several steps and in an alternate pattern.
Torque pressure: 12 ÷ 14 Nm
Keep the brake lever pulled back with a clamp as
shown in the figure on the left.
Tighten the front brake caliper fixing screws to the pre-
scribed torque.
Torque pressure: 42 ÷ 46 Nm
After completing the fitting operations, disengage the
front brake lever from the clamp.
Suspension and wheels
- 14 -
4
5
12 ÷ 14 N•m
42 ÷ 46 N•m
Advertisement
Table of Contents
