Table of Contents
Advertisement
FRONT WHEEL ASSEMBLY
(BRUTALE 750 ORO - 750 S - 910 S)
If the front tyre is substituted, before assem-
bling the wheel it is necessary to balance the
wheel following the indications in page 78.
After having carried out the check on the parts of the front
wheel, accurately clean the wheel spindle and assemble it
from right to left. Tighten the screw ring of the wheel spind-
le to the torque prescribed utilising the special tool. Ensure
that when the wheel is mounted into place, the screw ring
of the wheel spindle must be on the left side of the
motorcycle.
Screw ring of the frontal wheel spindle - Torque
pressure: 40 ÷ 44 N•m
Special tool N. 800092872
Mount the wheel, complete with wheel spindle onto the
F
wheel attachments of the front forks.
Ensure that the attachments do not sit on
the external face of the hexagon.
Tighten the two screws to the torque pressure prescri-
bed.
Mount the two brake calipers as described in chapter H
"Brakes".
Tightening torque of the fork attachment
fixing screws: 20 ÷ 22 N•m
During this phase it is necessary to support
the front wheel to avoid snagging the two
screws.
FRONT WHEEL ASSEMBLY
(BRUTALE 910 R - 989 R- 1078 RR)
If the front tyre is substituted, before assem-
bling the wheel it is necessary to balance the
wheel following the indications in page 78.
If the bearings have been replaced, refit the bearings,
the inner spacer, the two left and right outer spacers
and the brake discs on the wheel using the reverse pro-
cedure to the removal.
Suspension and wheels
- 12 -
40÷44 N•m
1
20÷22 N•m
Advertisement
Table of Contents
