Table of Contents
Advertisement
Gearchange/rear brake lever adjustment
To carry out the adjustment of the rear brake lever and
the gearchange lever, slacken the screw (1) utilising a
5 mm.Allen key. Adjust the position according to the
requirements of the rider utilising the same key and on
the hexagonal hole (2).
Tighten the screw (1) to the torque prescribed.
Brake lever adjustment torque pressure: 6
N . m
Operate on both the gearchange and rear brake levers
in the same way.
(Only for Brutale 750 ORO - 910 S - 910 R - 989 R -
1078 RR models)
Footrest adjustment
On some models, the footrests are adjustable. Operate
as follows for the adjustment from the original position:
• Slacken (without removing) the eccentric adjustment
screw (situated at the rear of the footrest support)
using a 12 mm hexagonal spanner.
• Loosen (without remove) the two fixing screws of the
frame board support using a 6 mm setscrew wrench.
• Lay (without tightening) the eccentric adjustment
rear screw. Effectuate the adjustment by utilising the
correct size screwdriver.
Adjust both footrests to the same adjustment
value.
• Tighten the two footrest fixing screws utilising a
torque wrench.
Torque pressure: 24 ÷ 28 N·m
• Tighten the rear eccentric adjustment screw.
Maintenance
- 73 -
B
6 N•m
24÷28 N•m
Advertisement
Table of Contents
