Miscellaneous Mvp Strings Back To The Master; Undock <Master; Dock; Txt - AMX MVP-7500 Operation/Reference Manual

Programming
"^" Button Commands (Cont.)

^TXT

Assign a text
string to those
buttons with a
defined address
range.

^UNI

Set Unicode text.

^VTP

Simulates a
touch/release/
pulse at the given
coordinate.

Miscellaneous MVP Strings back to the Master

The following two strings are sent by the MVP panel back to the communicating Master:
MVP Strings to Master
undock <master>

dock

126
Sets Non-Unicode text.
Syntax:
"'^TXT-<vt addr range>,<button states range>,<new text>'"
Variable:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
new text = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^TXT-500.504&510.515,1&2,Test Only'"
Sets the On and Off state text for buttons with the variable text ranges of
500-504 & 510-515.
For the ^UNI command (%UN and ^BMF command), the Unicode text is sent as
ASCII-HEX nibbles.
Syntax:
"'^UNI-<vt addr range>,<button states range>,<unicode text>'"
Variable:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
unicode text = Unicode HEX value.
Example:
SEND_COMMAND Panel,"'^UNI-500,1,0041'"
Sets the button's unicode character to 'A'.
Note: To send the variable text 'A' in unicode to all states of the variable text
button 1, (for which the character code is 0041 Hex), send the following command:
SEND_COMMAND TP,"'^UNI-1,0,0041'"
Note: Unicode is always represented in a HEX value. TPD4 generates (through the Text
Enter Box dialog) unicode HEX values. Refer to the TPDesign4 Instruction Manual for
more information.
Syntax:
^VTP-<0=Release, 1=Press, 2=Pulse>,<x>,<y>
This is sent to the target Master when the MVP is undocked.
• If the panel has no information within the User Access Passwords list, 'none' is sent as
a user.
• If the undock button on the Protected Setup page is used, 'setup' is sent as a user.
• This string can be disabled from within the firmware setup pages.
This is sent to the target Master when the MVP is docked.
• This string can be disabled from within the firmware setup pages.
MVP-7500/8400 Modero Viewpoint Wireless Touch Panels