Miscellaneous Mvp Strings; Undock-<User; Undocked; Swap - AMX MVP-9000i Operation And Reference Manual

Miscellaneous MVP Strings

The following two strings are sent by the MVP panel back to the communicating Master:
MVP Strings to Master
undock-<user>

UNDOCKED

SWAP

dock

MVP Panel Lock Passcode Commands

These commands are used to maintain a passcode list. With the MVP-9000i, a password must be entered to remove the
panel from the Wall Docking Station. Only the passcode is entered. The user entry is just for identifying the passcodes.
MVP Panel Lock Passcode Commands

^LPC

Clear all
users from the
User Access
Passwords list on
the Password
Setup page.

^LPR

Remove a given
user from the User
Access
Passwords list on
the Password
Setup page.

^LPS

Set the user name
and password.
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
This is sent to the target Master when the MVP undock button (or the docking station
undock button) is pressed and a valid password is entered (if password is set up).
• If the panel has no information within the User Access Passwords list, 'none' is sent as
a user.
• If the undock button in the System & Panel Options page (page 60) is used, 'setup' is
sent.
This is sent when the panel is physically removed from the dock.
This is sent after a panel swaps successfully from Wired to Wireless or from Wireless to
Wired. A successful swap occurs when there is not an offline and then online event from
the transition.
• This is sent to the target Master when the MVP is docked.
Syntax:
"'^LPC'"
Example:
SEND_COMMAND Panel,"'^LPC'"
Clear all users from the User Access Password list on the Password Setup page.
Refer to the section on page 84 for more information.
Syntax:
"'^LPR-<user>'"
Variable:
user = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^LPR-Robert'"
Remove user named 'Robert' from the User Access Password list on the Password
Setup page. Refer to the section on page 84 for more
information.
This command allows you to:
1. Add a new user name and password OR
2. Set the password for a given user.
The user name and password combo is added to the User Access and/or Password list
in the Password Setup page. The user name must be alphanumeric.
Syntax:
"'^LPS-<user>,<passcode>'"
Variable:
user = 1 - 50 ASCII characters.
passcode = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^LPS-Manager,undock'"
Sets a new user name as "Manager" and the password to "undock".
Example 2:
SEND_COMMAND Panel,"'^LPS-Manager,test'"
Changes the given user name password to "test".
Refer to the section on page 84 for more information.
Programming
135