Miscellaneous Mvp Strings; Undock <Master; Dock; Mvp Panel Lock Passcode Commands - AMX MVP-5200i-GB Instruction Manual

Miscellaneous MVP Strings

The following two strings are sent by the MVP panel back to the communicating Master:
MVP Strings to Master
undock <master>

dock

MVP Panel Lock Passcode Commands

These commands are used to maintain a passcode list. With the MVP-5200i, a password must be entered to remove the panel from
the Wall Charging Station. Only the passcode is entered. The user entry is just for identifying the passcodes.
MVP Panel Lock Passcode Commands

^LPC

Clear all users from the User Access Passwords list on the Password Setup page.
Syntax:
Example:

^LPR

Remove a given user from the User Access Passwords list on the Password Setup page.
Syntax:
Variable:
Example:

^LPS

Set the user name and password. This command allows you to: add a new user name and password OR set the password for a
given user. The user name and password combo is added to the User Access and/or Password list in the Password Setup page.
The user name must be alphanumeric.
Syntax:
Variable:
Example:
Example 2:
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
This is sent to the target Master when the MVP is undocked.
• If the panel has no information within the User Access Passwords list, 'none' is sent as a user.
• If the undock button on the Protected Setup page is used, 'setup' is sent as a user.
• This string can be disabled from within the firmware setup pages.
• This is sent to the target Master when the MVP is docked.
• This string can be disabled from within the firmware setup pages.
"'^LPC'"
SEND_COMMAND Panel,"'^LPC'"
Clear all users from the User Access Password list on the Password Setup page. Refer to the Other Settings section on
page 66 for more information.
"'^LPR-<user>'"
user = 1 - 50 ASCII characters.
SEND_COMMAND Panel,"'^LPR-Robert'"
Remove user named 'Robert' from the User Access Password list on the Password Setup page. Refer to the Other
Settings section on page 66 for more information.
"'^LPS-<user>,<passcode>'"
user = 1 - 50 ASCII characters.
passcode = 1 - 50 ASCII characters.
SEND_COMMAND Panel,"'^LPS-Manager,undock'"
Sets a new user name as "Manager" and the password to "undock".
SEND_COMMAND Panel,"'^LPS-Manager,test'"
Changes the given user name password to "test". Refer to the Other Settings section on page 66 for more information.
Programming
109