Miscellaneous Mvp Strings; Undock <Master; Dock; Mvp Panel Lock Passcode Commands - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Programming

Miscellaneous MVP Strings

The following two strings are sent by the MVP panel back to the communicating Master:
MVP Strings to Master
undock <master>

dock

MVP Panel Lock Passcode Commands

These commands are used to maintain a passcode list. With the MVP-5200i, a password must be entered to
remove the panel from the Wall Charging Station. Only the passcode is entered. The user entry is just for
identifying the passcodes.
MVP Panel Lock Passcode Commands

^LPC

Clear all
users from the
User Access
Passwords list on
the Password
Setup page.

^LPR

Remove a given
user from the User
Access
Passwords list on
the Password
Setup page.

^LPS

Set the user name
and password.
120
This is sent to the target Master when the MVP is undocked.
• If the panel has no information within the User Access Passwords list, 'none' is sent as
a user.
• If the undock button on the Protected Setup page is used, 'setup' is sent as a user.
• This string can be disabled from within the firmware setup pages.
• This is sent to the target Master when the MVP is docked.
• This string can be disabled from within the firmware setup pages.
Syntax:
"'^LPC'"
Example:
SEND_COMMAND Panel,"'^LPC'"
Clear all users from the User Access Password list on the Password Setup page.
Refer to the Other Settings section on page 76 for more information.
Syntax:
"'^LPR-<user>'"
Variable:
user = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^LPR-Robert'"
Remove user named 'Robert' from the User Access Password list on the Password
Setup page. Refer to the Other Settings section on page 76 for more
information.
This command allows you to:
1. Add a new user name and password OR
2. Set the password for a given user.
The user name and password combo is added to the User Access and/or Password list
in the Password Setup page. The user name must be alphanumeric.
Syntax:
"'^LPS-<user>,<passcode>'"
Variable:
user = 1 - 50 ASCII characters.
passcode = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^LPS-Manager,undock'"
Sets a new user name as "Manager" and the password to "undock".
Example 2:
SEND_COMMAND Panel,"'^LPS-Manager,test'"
Changes the given user name password to "test".
Refer to the Other Settings section on page 76 for more information.
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom