Husqvarna DUAL PURPOSE TE 610 I.E Owner's Manual page 99

ADJUSTING THE FORK (Fig. 31)
a) COMPRESSION
(LOWER ADJUSTER)
Standard calibration: -12 clicks. Remove
plug (B) and turn adjuster (A) clockwise until
the position of fully closed is reached then,
turn back by the mentioned clicks.To obtain
a smoother braking action, turn the adjuster
anticlockwise. Reverse the operation in
order to obtain a harder action.
WARNING: Never force the adjusting screws beyond the maximum opening and closure
positions.
2-ENG 8000 B0836.indd 37 2-ENG 8000 B0836.indd 37
b) EXTENSION (UPPER ADJUSTER)
Standard calibration: - 12 clicks. To reset
standard calibration turn adjuster (C)
clockwise to reach the position of fully
closed; then, turn back by the mentioned
clicks. To obtain a smoother braking action,
turn the adjuster anticlockwise. Reverse
the operation in order to obtain a harder
action.
FIG. 31
A: Lower adjuster -compression
B: Plug
C: Upper adjuster -extension
D: Air vent
c) AIR VENT (to carry out after each
competition, or monthly). Set the motorcycle
on a central stand and release the fork fully
and loosen the air vent valve (D).
Once this operation is over, tighten the
valve.
37
26-09-2007 10:05:16 26-09-2007 10:05:16