Husqvarna DUAL PURPOSE TE 610 I.E Owner's Manual page 115

SM 610
By a loosening screw (1), correct orienting
of headlamp is possible, and by pushing
the headlamp lower or upper side, the light
beam is rised or lowered operation is over,
tighten screw (1). Use a 5/16" "socket-
wrench to turn the screw.
FIG. 41
1. Headlamp vertical adjusting screw
SM 610
2-ENG 8000 B0836.indd 53 2-ENG 8000 B0836.indd 53
TE 610
Adjust the headlamp aiming by turning screw
(1) to lower or lift the high beam.
TE 610
TOOLS (Fig. 42)
The tool kit for the usual maintenance
operations is housed in kit (1) under
the saddle. First turn the rear fi xing pin
anticlockwise, then remove the saddle to
gain access to the kit.
Series of tools inside the kit:
- Setscrew wrench - 5 mm;
- Setscrew wrench - 6 mm;
- Socket spanner- 16 mm;
- Socket spanner- 8-10 mm;
- Double ended wrench- 8/10
mm;
- Double ended wrench- 12/13
mm;
- Double ended wrench- 14/15
mm;
- Wrench- 27 mm;
- Hexagonal wrench;
- Front wheel axle wrench;
- Box wrench- 15x27mm;
- Screwdriver.
FIG. 42
1. Tools bag
53
26-09-2007 10:05:28 26-09-2007 10:05:28