Husqvarna DUAL PURPOSE TE 610 I.E Owner's Manual page 113

- remove the two fi laments bulb connector;
(2) and the boot (3);
- release the bulb holding spring (4) and then
the bulb itself.
To replace the parking light bulb, (5) extract
it from the inside cover.
After replacement, reverse operations for
reassembly.
Check the wiring harness of the headlamp
in the assembling phase.
2-ENG 8000 B0836.indd 51 2-ENG 8000 B0836.indd 51
REPLACING THE TURN INDICATOR
BULBS (Fig. 39)
Place a little screwdriver into the lower hole
of the turn indicator then remove the lens
(1) and the lamp housing (2). Pull gently
outside the lamp (3) using a pliers. Pull the
lamp inside, turn it counterclockwise then
remove it from the lamp holder. This done,
reverse operations for reassembly.
FIG. 39
1. Lens
2. Lamp housing
3. Lamp
51
26-09-2007 10:05:26 26-09-2007 10:05:26