Husqvarna DUAL PURPOSE TE 610 I.E Owner's Manual page 89

2) Because the cooling fan can be
activated even when the start switch is
in OFF position, always keep at a safe
distance from the fan vanes.
3) Because hard water scales the
elements of the cooling system, never
use water but in exceptional cases, and
replace the required liquid as soon as
possible (see page 28).
4) After several fi llings, check the system
for detecting possible leaks.
NOTE*: Difficulties may arise in
eliminating coolant from varnished
surfaces. If this occurs, wash off with
water.
2-ENG 8000 B0836.indd 27 2-ENG 8000 B0836.indd 27
REPLACEMENT OF COOLANT (Fig. 18)
Replace according to the terms fi xed in the
"Periodical Maintenance Card". Set a
vessel under the engine and work as
follows:
- remove the right radiator cap and the
cooling fl uid drain screw (A) set to the right
of the cylinder. When the fl uid is fully
drained, reassemble the drain screw and
check the gasket and fi ll the right reservoir
with the required quantity (see page 7).
Slowly turn the engine to eliminate possible
air bubbles, then check the levels again,
following the instructions on page 26.
FIG. 18
A. Vite scarico refrigerante
B. Tappo radiatore
26-09-2007 10:05:10 26-09-2007 10:05:10
27