Husqvarna DUAL PURPOSE TE 610 I.E Owner's Manual page 103

Tighten the screw (3) on the fork L.H. side
but DO NOT lock it. Now, pump for a while,
pushing the handlebar downwards until
you are sure that the fork legs are perfectly
aligned. Lock: the screws (1) on the R.H. leg
(10,4 Nm/ 1,05 Kgm/ 7.7 ft-lb), the screw (3)
on the L.H. side (51,45 Nm/ 5,25 Kgm/ 38
ft-lb), the screws (1) on the L.H. leg (10,4
Nm/ 1,05 Kgm/ 7.7 ft-lb).
2-ENG 8000 B0836.indd 41 2-ENG 8000 B0836.indd 41
SM: fit the brake caliper on the disc;
assemble the caliper on its holding plate
and tighten the screws (A) at 25,5 Nm/ 2,6
Kgm/ 18.8 ft-lb. Check that the brake disc
slides between the caliper pads without any
friction. After reassembly, pump the brake
control lever until the pads are against the
brake disc.
41
26-09-2007 10:05:18 26-09-2007 10:05:18