Husqvarna DUAL PURPOSE TE 610 I.E Owner's Manual page 112

IMPORTANT
The headlamp bulb (6) is an halogen type
bulb; pay attention not to touch the bulb
glass with bare hands.
FIG. 37
6. Two fi lament bulb
7. Connector
8. Parking light bulb
50
2-ENG 8000 B0836.indd 50 2-ENG 8000 B0836.indd 50
To replace the parking lamp,
unhook the bulb connector (7) then extract
the bulb (8) from the inside cover.
This done, reverse operations for reassembly.
Check the wiring harness of the headlamp
in the assembling phase.
HEADLAMP BULBS
REPLACEMENT (Fig. 38-TE 610)
To gain access to the healamp bulbs,
proceede as follows:
- remove the two fastening elastics (1) and
the headlamp holder;
FIG. 38
1. Elastic
2. Connector (page 51)
3. Bulb rubber protection (page 51)
4. Spring (page 51)
5. Parking light bulb (page 51)
26-09-2007 10:05:25 26-09-2007 10:05:25