Wiring Diagrams; Electrical System Specifications - Polaris 1999 Sportsman 400 Service Manual

ELECTRI CAL SYST EM
7.
Install by reversing
these steps while noting the
following:
CAUTION
The internal contacts ofboth s witches
are different (Figure 90) and they
must he reinstalled ill the correct 10-
335
ca lion Oil the transm ission case.
Ifin-
stalled incorrectly, the switches wilt
be da maged.
a. Refer to the F mark made in Disassem bly Step
4. Install the fro nt gear indicator switch with
a n F (front) (F, Figure 89) in the front recep-
tacle. Install the screws and tighten
securely,
h. Install the rea r gea r indicat or switch (R. Fig-
ure 89 ) in the rear receptacle. Install the
screws and tighten sec urely.
c. Make sure the electrical conn ectors an: free of
corrosion.
d. Make sure all of the elec trica l connectors are
sec ure.
WIRING J)(AGRUIS
Wiring diagrams for all models are located at the
end of this book .
Item
Table 1 ELECTRICAL SYSTEM SPECIFICATIONS
Specification
Alternator output
1996-1997
1998-on
Between yellow and yellow/red
Alternator stator coils
Exciter calls (1996-1998)
Between red and green
Between black/red and green
Exciter colis (1999-00)
Betwe en red and green
Between black/red and green
Trigger co il
Between white and white/red
Charge call (1996-1998)
Yellow to yellow/brown
Yellow/red to yellow/brown
Charge coil (1999-0n)
Yellow to yellow/red
Yellow to ground
Bush len gth minimum
Ignit ion coli
Primary resistance
Secondary resistance
Spark plug cap resistance
Starter so leno Id resistance
200 watts
250 watts
7amps
3.2 ohms
446 ohms
1.6 ohms
446 ohms
97 ohms
0.17 ohms
0.17 ohm s
0.13 ohms
infi nity
0.6 m m (0.031 In.)
0.3 ohms
6300 ohm s
5000 ohms
3.4 ohms