Replacing Or Clearing Nvram - Toshiba e-STUDIO230L Service Handbook

Hide thumbs Also See for e-STUDIO230L:

Table of Contents

Replacing or clearing NVRAM

<<Caution in replacing or clearing NVRAM>>

When NVRAM has been replaced or cleared ("System all clearing (08-669)"), the setting must be per-

formed according to the following procedure.

Take off the FAX board if installed.

Start up with the Setting Mode (08).

Check the serial number after performing 08-995 (Equipment number display). If the number is

different from the one on the label attached to the rear cover of the equipment, enter the correct

serial number again with 08-995.

The MAC address of the equipment is generated based on this serial number. Entering the incor-

rect serial number may result in an inability to access the network due to an invalid MAC

Perform 08-693 (initialization of the NIC information).

Perform "1: Electrical counter -> Backup counter" of 08-257 (Counter copy) to recover the total

Shut down the equipment.

Install the FAX board taken off in step (1).

* If the FAX board has not been installed, the following steps are not necessary.

Start up with the Setting Mode (08).

Set the destination with 08-701 (Destination setting of FAX machine).

(10) Start up with the FAX Clearing Mode (1*).

(11) Perform 1*-100 (FAX Set Up).

(12) Turn the power OFF.

(13) Turn the power ON.

(14) Set the dial type. [USER FUNCTIONS] → [ADMIN] → [FAX] → [INITIAL SETUP]

e-STUDIO200L/202L/203L/230/232/233/280/282/283

TROUBLESHOOTING

Table of Contents