Toshiba e-STUDIO230L Service Handbook page 462

[E550] Paper remaining on the transport path
Open the cover of the unit/area whose picture is blinking on the control panel. Is there any
paper on the transport path?
YES
NO
Is the sensor in the jamming area working? (Perform the input check in the test mode: refer
to the following table)
l NO
l
l
l
l
l
l
l
YES
Replace the LGC board.
Relation between the jamming area and the corresponding sensors/covers
(If a jam is occurring in the ADU, LCF, PFP, JSP or OCT check the board in each unit.)
Jamming area
Registration area Transfer cover
Exit area Transfer cover
ADU ADU
Feeding area Side cover
(Main unit)
LCF LCF side cover
PFP PFP side cover
Bridge unit Bridge unit
JSP JSP cover
OCT OCT cover
Finisher Finisher door
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
Remove the paper.
1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the sensor.
6) Replace the LGC board.
Cover
Registration sensor
1st transport sensor
Exit sensor
ADU entrance sensor
ADU exit sensor
2nd transport sensor
LCF feed sensor
PFP upper drawer feed sensor
PFP lower drawer feed sensor
Bridge unit transport sensor-1
Bridge unit transport sensor-2
JSP feed sensor
OCT feed sensor
Sensors in the finisher
5 - 10
Sensor Test mode/Input check
03-[FAX]ON/[2]/[A]
03-[FAX]OFF/[6]/[E]
03-[FAX]ON/[2]/[B]
03-[FAX]OFF/[1]/[H]
03-[FAX]OFF/[1]/[G]
03-[FAX]OFF/[7]/[E]
03-[FAX]OFF/[5]/[G]
03-[FAX]OFF/[2]/[D]
03-[FAX]OFF/[4]/[D]
03-[FAX]ON/[3]/[H]
03-[FAX]ON/[3]/[E]
03-[FAX]ON/[3]/[H]
03-[FAX]ON/[3]/[H]
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
-