Adjustment Of Reverse Solenoid - Toshiba e-STUDIO230L Service Handbook

3.10.7

Adjustment of reverse solenoid

When operating the reverse solenoid, adjust it if the position of the flapper lever is out of the following
dimension.
Gap between A of the front frame and the flapper lever "C": 0.5 mm to 2.0 mm
<Procedure>
(1) Remove the screw on the left and take off the
plate spring.
(2) Align B of the front frame with the edge of the
reverse solenoid, and temporarily fix the
reverse solenoid with the screw on the right.
(3) While the plunger of the reverse solenoid is
put in the position to be turned ON (by press-
ing it in the direction of an arrow), loosen the
screw on the right to adjust the reverse sole-
noid so that the gap (C) between A of the
front frame and the flapper lever is 0.5 mm to
2.0 mm.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
ADJUSTMENT
Plate spring
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
3 - 64
Fig. 3-71
B
Fig. 3-72
A
C
Fig. 3-73