Toshiba e-STUDIO230L Service Handbook page 424

[ 2 ] Operational screen
1) Main screen
1
2
Displaying of the main unit name
1
Back to the PM support mode activation screen
2
Clearing of the chosen unit counters (all the sub unit (parts) counters belonging to that unit)
3
All counters are cleared when the unit is not selected
Moving to the sub screen
4
Moving to the next/previous page
5
Displaying of the standard number of output pages counts (x 1,000) to replace the unit parts
6
Displaying of the present drive counts (x 1,000)
7
"*" is displayed next to the present number when the number of drive counts has exceeded its
PM standard number.
Displaying of the standard number of drive counts (x 1,000) to replace the unit parts
8
Displaying of the present number of output pages counts (x 1,000)
9
When there are differences among the sub units (parts), "_" is displayed and "CHECK SUB-
UNIT" is displayed at the top
"*" is displayed next to the present number when the number of output pages counts has
exceeded its PM standard number.
Displaying of the number of output pages counts (Cpy.), drive counts (Cnt.) and previous
10
replacement date (Chg.) for a chosen unit.
When the replacement date for the sub unit is different, press the [SUB UNIT] button to move
to the sub screen and see each information, otherwise information is not displayed
Notes:
• "—" is always displayed at the drive counts section for the reversing automatic document
feeder (RADF) and feed unit.
• The paper source differs depending on the structure of options, however, "0.0k" is displayed
in "OUTPUT PAGES (k)" and its standard number of output pages is displayed in "PM OUT-
PUT PAGES (k)" even for the installed paper source.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
PREVENTIVE MAINTENANCE (PM)
10
3 4
9
5 6
Fig. 4-2
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
4 - 2
7 8