Toshiba e-STUDIO230L Service Handbook page 525

[CCB0] Rear jogging plate motor abnormality/Alignment motor (rear) abnormality
MJ-1022 (Rear jogging plate motor abnormality)
Is the rear jogging plate home position sensor (S7) working properly?
NO
YES
Is the wiring between the finisher controller PC board and rear jogging motor (M4) correct?
NO
YES
Has the rack run over the stopper of the roll?
YES
NO
1) Replace the rear jogging motor.
2) Replace the finisher controller PC board.
MJ-1025 (Alignment motor (rear) abnormality)
Is the aligning plate home position sensor (rear) (PI5) working properly?
NO
YES
Is the wiring between the finisher controller PC board and aligning plate home position sen-
sor (rear) correct?
NO
YES
Is there any mechanical problem with the path of aligning plate?
YES
NO
Try replacing the alignment motor (rear) (M5). Is the problem corrected?
YES
NO
Replace the finisher controller PC board.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Replace the sensor.
Correct the wiring.
Fix it.
Replace the sensor.
Correct the wiring.
Fix the mechanism.
End.
5 - 73
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
5