Toshiba e-STUDIO230L Service Handbook page 477

Hide thumbs Also See for e-STUDIO230L:
Table of Contents

Advertisement

[E430]
ADU opened during printing
Is the ADU open?
YES
NO
Is the ADU opening/closing switch working?
(Perform the input check in the test mode: 03-[FAX]OFF/[1]/[F])
l
NO
l
l
l
l
l
l
l
l
l
l
l
YES
1) Replace the ADU board.
2) Replace the LGC board.
[E440]
Side cover opened during printing
Is the side cover open?
YES
NO
Is the side door switch working?
(Perform the input check in the test mode: 03-[FAX]ON/[2]/[F])
l
NO
l
l
l
l
l
l
l
YES
Replace the LGC board.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Remove the paper if there is any, then close the ADU.
1) Check if the connector of the ADU opening/closing switch is discon-
nected.
2) Check if either of the connectors CN562 or CN217 on the ADU board
is disconnected.
3) Check if the connector CN304 on the LGC board is disconnected.
4) Check if the connector pins are disconnected and the harnesses are
open circuited.
5) Check if the conductor patterns on the ADU board and LGC board
are short circuited or open circuited.
6) Replace the ADU opening/closing switch.
7) Replace the ADU board.
8) Replace the LGC board.
Remove the paper if there is any, then close the cover.
1) Check if the connector of the side door switch is disconnected.
2) Check if the connector CN304 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the side door switch.
6) Replace the LGC board.
5 - 25
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
5

Advertisement

Table of Contents
loading

Table of Contents