Toshiba e-STUDIO230L Service Handbook page 599

[A] Update Procedure
Since the procedure differs depending on the data, see the each procedure below.
Important:
• Turn OFF the power before installing or removing the download jig.
• Do not turn OFF the power during the update. The data could be damaged and not be oper-
ated properly.
<Updating Engine ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-4 "Fig. 6-3").
(2) Turn OFF the power of the equipment.
(3) Take off the connector cover.
(4) Remove the cover plate.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Connector cover
Fig. 6-20
Cover plate
Fig. 6-21
e-STUDIO200L/202L/203L/230/232/233/280/282/283
6 - 23
FIRMWARE UPDATING
6