Toshiba e-STUDIO230L Service Handbook page 497

[ 4 ] Paper jam in saddle stitcher section
[EAB0] Saddle paper transport stop jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
YES
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
YES
NO
Is the folding position sensor working properly?
NO
YES
Replace the finisher controller PC board.
[EAC0] Saddle transport delay jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
YES
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
YES
NO
Is the folding position sensor working properly?
NO
YES
Replace the finisher controller PC board.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Remove the paper.
Connect the connector securely. Replace the harness.
Replace the sensor.
Remove the paper.
Connect the connector securely. Replace the harness.
Replace the sensor.
5 - 45
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
5