Toshiba e-STUDIO230L Service Handbook page 81

Procedure 6
[Digital key]
[0][5]
(Code)
[POWER]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 7
[Digital key]
[0][5]
(Code)
[POWER]
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 17
[CANCEL] or [CLEAR]
[0][5]
[Digital key]
[START]
[POWER]
(Code)
Manual
adjustment
[CANCEL] or [CLEAR]
* When the "storing is not performed within 2 minutes after pressing the [START] button at the
manual adjustment, the "automatic adjustment" starts automatically.
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Automatic
(
[START]
adjustment
*[CANCEL] or [CLEAR]
[CANCEL]
Automatic
(
[START]
adjustment
[Digital key]
[START]
(Sub code)
[SET] or [INTERRUPT]
(Value unchangeable)
(
[UP]
( )
Automatic
adjustment
[DOWN]
(Adjust a value)
[UP]
or
[DOWN]
(Adjust a value)
2 - 45
) ([FAX])
(Test copy)
[ENTER]
)
([FAX])
Stores value
( )
(Test copy)
in RAM
Value
( )
[START]
displayed
[ENTER]
)
or
or
(Test copy)
[INTERRUPT]
Stores value
( )
in RAM
[ENTER]
or
[INTERRUPT]
Stores value
( )
in RAM
e-STUDIO200L/202L/203L/230/232/233/280/282/283
ERROR CODE AND SELF-DIAGNOSTIC MODE
[POWER]OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
[POWER]
[START] OFF/ON
(Exit)
[POWER]
([FAX])
OFF/ON
(Exit)
2