Toshiba e-STUDIO230L Service Handbook page 265

Setting mode (08) <e-STUDIO202L/203L/232/233/282/283>
Classifi-
Code
cation
1773 General Card reader format infor-
mation -1
1774 General Card reader format infor-
mation -2
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Default
Func- <Accept-
Items
tion
value>
ALL
ALL
2 - 229
07/11
RAM Contents
able
- SYS To access the data in
the noncontact IC card,
the Key Information
"LLLL" and the Sector
Number "MMMM"
should be set.
The "LLLL" should be
set first, and then
"MMMM".
KP-2003:
LLLL: System code
(hexadecimal number)
MMMM: Service code
(hexadecimal number)
KP-2005:
LLLL :
Key information
MMMM:
Sector number
(hexadecimal number)
- SYS The data of the block
number in the noncon-
tact IC is set.
KP-2003: <PPQRSSTU
(hexadecimal number)>
PP:1st block
Q: 1st block beginning
byte
R: 1st block ending-
byte
SS:2nd block
T: 2nd block begin-
ning byte
U: 2nd block ending
byte
KP-2005: <RRBSEbse
(hexadecimal number)>
RR:00 (Fixed)
B: 1st area block num-
ber
S: 1st area beginning
byte offset
E: 1st area ending byte
offset
b: 2nd area block
number
s: 2nd area beginning
byte offset
e: 2nd area ending
byte offset
* If the 2nd block/area is
not used, set the SSTU
to "FFFF" (hexadeci-
mal number), the bse
to"FFF" (hexadecimal
number).
e-STUDIO200L/202L/203L/230/232/233/280/282/283
ERROR CODE AND SELF-DIAGNOSTIC MODE
Proce-
dure
5
2
5