Handling Setting Data; Setting Data File Configuration; Handling Sd Memory Cards - Panasonic AJ-PX5000G Operating Instructions Manual

Handling setting data

Setting data file configuration

The camera has six file data areas.
Factory data
User data
Current data
Scene file
Lens file
CAC file
[SETUP DATA (SD CARD)]
Menu operation
Setting valve changed
[INITIALIZE]
[SAVE USER DATA]
[INITIALIZE]
↓
[LOAD FACTORY DATA]
Factory data
(cannot be rewritten)
Number of files: 1
: Camera internal files
: Menu operation
@ NOTE
t For details on items for setup data, user data, and scene file, etc., refer to "Setting items to [USER MENU] and loading/reading the settings to a data
file" (page 179).
t When recording of a clip by linking to the previous clip is possible in one-clip recording ([1*CLIP] is displayed), you cannot operate a scene file or a
user file. Close the menu once, press and hold the <STOP> button for approx. 2 seconds to end linking of clips, and then try the operation again. The
same applies to interval recording or during standby in one-shot recording.
Setting up using SD memory cards
An SD memory card (optional) can be used as a setup card that stores setting menu content.
Use of this data allows you to quickly reproduce optimum setup states.

Handling SD memory cards

The SD memory card can be removed and inserted, either before or after the power is turned on.
Chapter 4 Adjustments and Settings for Recording — Handling setting data
This area stores factory settings. It cannot be rewritten by menu operation.
This area stores values set by menu operation. As default data, factory data is stored here.
This area stores the operation status of the camera. Setting values in this area are changed by menu operation.
Four scene files are provided.
Eight lens files are provided. Eight of these files can be saved together as a single file on SD memory card.
This area stores 32 chromatic aberration compensation data.
SD memory card
Setup data
[SETUP DATA (SD CARD)]
↓
[LOAD]
Current data
(operation status of camera)
Number of files: 1
[LOAD USER DATA]
↓
User data
Number of files: 1
[CAC FILE (SD CARD)]
↓
[LOAD]
Number of files: 32
↓
[SAVE]
[CAC ADJ] → [CAC CONTROL]
[SCENE]
[SAVE]
[SCENE]
[LOAD]
[LENS FILE]
[LOAD]
[LENS FILE]
[SAVE]
[LENS FILE (SD CARD)]
↓
[LOAD]
8 setup files can be written to SD memory card.
– 91 –
SD memory card
CAC file
↓
Scene file
Number of files: 4
↓
↓
Lens file
Number of files: 8
↓
[LENS FILE (SD CARD)]
↓
[SAVE]
SD memory card
Lens file
Number of files: 8×8