t Manual authentication is valid temporarily. If the target microP2 card is removed or power is turned off, the CPS password set manually is disabled.

t Visit the following website for conditions where manual authentication is valid.

http://pro-av.panasonic.net/

t The encrypted microP2 memory card is not recognized on the SD card slot in a computer.

t If the card is unable to be recognized, authenticate with the correct password, or format the card and use it as recording media, or remove it from the

camera. Do not perform any operation other than manual authentication and formatting with the failed card inserted.

SD memory card status display

The status display enables confirmation of the SD memory card format condition, available memory space, etc.

Select [SD CARD] in the main menu → [CLIP] → [PROPERTY]. The same information can be displayed in the main menu → [FILE] → [SD CARD

PROPERTY].

[SD STANDARD]

Indicates whether an SD memory card is formatted according to the SD/SDHC/SDXC standard.

f [SUPPORTED]: Complies with SD/SDHC/SDXC standards

f [NOT SUPPORTED]: Does not comply with SD/SDHC/SDXC standards

[USED]

Used capacity (bytes)

[BLANK]

Available space (bytes)

[TOTAL]

Total capacity (bytes)

[PROXY REM]

Remaining capacity for proxy recording

[NUMBER OF CLIPS]

The number of clips on an SD memory card when clips have been copied to an SD memory card

[PROTECT]

Write-protected status

Connecting to external devices using the <USB3.0> terminal (host) (USB storage mode)

You can use an HDD or SSD that can be connected via USB 2.0/USB 3.0. However, there are certain storage devices that cannot be used depending

on the device.

Storage device types and available functions

The available functions differ depending on the storage device you will use. The storage device type is displayed after [PARTITION] on the left side of

the storage device explorer screen.

For details, refer to "Storage device information display (explorer screen)" (page 132).

r Storage device type

Storage device type

[TYPE S]

[P2STORE]

[FAT]

[OTHER]

* The hierarchy of folders is down to the 3rd level and the maximum number of folders is 100. Long file names and file names with double-byte characters are not

supported. Examples of folder displays are shown below.

/CONTENTS

/SAMPLE/CONTENTS

/SAMPLE/20090101/CONTENTS

/SAMPLE/20090101/1200/CONTENTS

Chapter 6 Thumbnail Operations for Clips — Thumbnail operations

A special format to enable fast read/write by card.

Indicates P2 STORE (AJ-PCS060G). Writing is disabled.

Storage devices where the primary partition is FAT16 or FAT32. The partition root or CONTENTS folder

under any folders* is the target.

Indicates other storage devices other than the above. File systems other than FAT16 and FAT32, such as

NTFS.