Setting The Region Of Use (Setting Frame Frequency, Etc.) - Panasonic AJ-PX5000G Operating Instructions Manual

Setting the region of use (setting frame frequency, etc.)

When the camera is shipped, the region of use is not set. Before you use the camera for the first time, follow the steps below to change the setting to
the frame frequency of the region of use.
1
When the region of use is not set, connect the camera's power and set the <POWER> switch to <ON>.
The [AREA SELECT] screen for setting the region of use is displayed.
2
Use the jog dial button (or cursor buttons `/{) to select the region from the [NTSC]/[NTSC (J)] (Japan)/[PAL] and press the jog
dial button (or <SET> button).
3
Select [YES] in the confirmation message, and press the jog dial button (or <SET> button).
The camera will be initialized according to the region of use selected and automatically restart.
After setting up the camera once, this screen will not be displayed when subsequently turning the power on. To change the region of use, configure
the setting in [OPTION MENU] → [AREA SETTING] → [AREA SELECT].
@ NOTE
t When making this setting to use the camera for the first time, only the following items are changed on the camera. Menu setting values other the
following items stay at their factory settings.
[LINE&FREQ]
Camera mode
[SETUP(7.5%)]
[REAR LINE IN LVL]
[AUDIO OUT LVL]
[HEADROOM]
GUI metadata language
display
[LANGUAGE]*
* For details, refer to "Setting metadata display language" (page 124).
Chapter 1 Overview — Setting the region of use (setting frame frequency, etc.)
Factory settings
[1080-59.94i]
60i
[ON]
[4dB]
[4dB]
[20dB]
US English
No display
[NTSC]
[1080-59.94i] [1080-59.94i]
60i
[ON]
[4dB]
[4dB]
[20dB]
US English Japanese/for Japan
No display
[JAPANESE]
– 11 –
[NTSC (J)]
[1080-50i]
60i
[OFF]
[4dB]
[4dB]
[20dB]
US English
[ENGLISH]
No display
[PAL]
50i
[OFF]
[0dB]
[0dB]
[18dB]