Panasonic AJ-PX5000G Operating Instructions Manual page 135

[NO.]
[DATE]
[TIME]
[FOLDER]
[SIZE]
[FREE CAP.]
@ NOTE
t You can change the thumbnail screen display if necessary.
t The 1001st clips onwards are not displayed.
Displaying clip information
You can display each type of metadata of clips saved in a storage device. The display mode is the same as the P2 card clip properties.
1
In the storage device thumbnail screen, move the cursor to the target clip.
2
Press the <MENU> button.
3
Select [CLIP PROPERTY] in the main menu → [CLIP] → [PROPERTY] and press the <SET> button.
This cannot be modified.
Deleting clips
You can delete unnecessary clips saved in a storage device.
1
In the storage device thumbnail screen, select the clip you want to delete.
2
Press the <MENU> button.
3
Select [DELETE] in the main menu → [CLIP] and press the <SET> button.
4
Move the cursor to [YES] in the confirmation message and press the <SET> button.
@ NOTE
t You may not be able to delete clips with defective clip or unknown clip indicators.
Writing back to the P2 card from a storage device (import)
Importing from a [TYPE S] storage device or [P2STORE] by partition
You can import (write back to a P2 card from as storage device) to a P2 card with the same part number as the source card by partition (card).
1
Insert a P2 card that will serve as the input destination.
Make sure to insert a formatted P2 card.
2
Connecting a storage device.
3
Select [STORAGE] in the main menu → [CLIP] → [EXPLORE] to display the explorer screen.
4
In the explorer screen, display the partition thumbnails to be imported.
5
Select [IMPORT] in the main menu → [CLIP].
6
Place the cursor on the import destination P2 card slot number and press the <SET> button.
Start importing by selecting [YES] in the confirmation message.
[COPY COMPLETED!] will be displayed when importing is completed.
@ NOTE
t Importing to a P2 card that is different from the source P2 card may result in incomplete clips depending on the clips. In this case, use the
reconnection function to reconfigure the clips.
t You can switch verification during copying on and off by setting the main menu → [CLIP] → [STORAGE COPY SETUP] → [VERIFY].
t You cannot import by partition to a P2 card of a different model. Perform copying by clip instead.
Copying to a P2 card by clip
You can specify a storage device clip and copy it to a P2 card.
1
Open the storage device thumbnail screen.
2
Select the clip you want to copy.
3
Press the <MENU> button.
4
In the main menu → [CLIP] → [COPY] → [STORAGE] list, move the cursor over the copy destination and press the <SET> button.
Start importing by selecting [YES] in the confirmation message.
[COPY COMPLETED!] will be displayed when copying is completed.
Chapter 6 Thumbnail Operations for Clips — Thumbnail operations
Folder number
Folder creation date
Folder creation time
Folder name (creation date and time are not displayed in the root folder)
Total capacity of the storage device
Remaining storage device capacity
– 135 –