Warning System; Warnings Description List - Panasonic AJ-PX5000G Operating Instructions Manual

Warning system

Warnings description list

If an error is detected immediately after the camera turns on or during operation, the <WARNING> lamp, the lamp on the viewfinder screen, and an
alarm indicate the error.
@ NOTE
t The priority order of each item is the warning lamp, tally lamp, and alarms, and if multiple errors occur simultaneously, highest priority one is indicated.
"Reduced wireless audio reception" may not be indicated depending on the setting in the main menu → [I/F SETUP] → [MIC/AUDIO] → [WIRELESS
WARN].
1 System error
Display in display window
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
2 Mismatched format
Display in display window
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
3 Card removal error
Display in display window
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
4 Battery end (low voltage input)
Display in display window
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
5 P2 card end
Display in display window
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
Chapter 10 Maintenance and Inspection — Warning system
The error code is displayed in the time code display.
Flashes four times per second.
Flashes four times per second.
The [SYSTEM ERROR] display, error codes, and, on the lower line of these, the cause are displayed.
Sounds continuously.
Standard signal error or communication error.
Stops.
Check the factor display "Error code" and consult your dealer.
The error code [E-31] is displayed in the time code display.
Flashes four times per second.
Flashes four times per second.
[TURN POWER OFF] and [SYSTEM MODE] are displayed.
Sounds continuously.
An internal mismatch occurs in system mode and a restart is required.
Does not operate.
Follow the message to turn the power off once, turn the power on again, and check that there is no error display.
The error code [E-30] is displayed in the time code display.
Flashes four times per second.
Flashes four times per second.
[TURN POWER OFF] and [P2 CARD] are displayed.
Sounds continuously.
An error occurred in the camera built-in memory because the P2 card being accessed was ejected.
Does not operate.
Follow the message to turn the power off once and turn the power on again. Ensure that there is no error in the clips on
the ejected card, and repair the clips as necessary.
Seven battery charge level bars flash.
Lights.
Flashes once per second.
The [BATT] lamp is illuminated if the viewfinder has the [BATT] lamp. [EMP] flashes in the battery charge level display.
([%] flashes for [BATT STAT] and [ENDURA STAT].)
Sounds continuously.
The battery has run out.
Stops.
Change the batteries.
If the external AC adaptor is inserted from the <EXT DC IN> terminal, the warning will be released.
Seven media charge level bars flash.
It stays illuminated until some operation is performed after recording.
It continues to flash four times per second until some operation is performed after recording.
The [END] display flashes in the P2 remaining charge display.
(If the viewfinder has the [SAVE] lamp, and [P2CARD] is set in the main menu → [VF] → [VF INDICATOR] → [SAVE
LED], the [SAVE] lamp flashes four times per second.)
It continues to sound until some operation is performed after recording.
The P2 card space is used up.
Recording will stop.
Delete clips in the recording media or insert a new recording media.
– 220 –