Panasonic AJ-PX5000G Operating Instructions Manual page 150

Item
[VF DTL] Sets the detail level of the viewfinder screen.
Further emphasizes details of the viewfinder signal. If [0], the detail is the same as
this line.
[0]...[5]...[10]
[ZEBRA1 DETECT] Sets the ZEBRA1 extraction level (IRE value).
[0%]...[70%]...[109%]
[ZEBRA2 DETECT] Sets the ZEBRA2 extraction level (IRE value).
[0%]...[85%]...[109%]
[ZEBRA2] Switches [ZEBRA2] [ON]/[OFF] and selects SPOT.
[ON], [SPOT], [OFF]
[LOW LIGHT LVL] Sets how low the amount of light entering the camera must be to display [LOW
LIGHT].
[OFF], [10%], [15%], [20%], [25%], [30%], [35%]
[RC MENU DISP.] Sets whether to display the menu on the viewfinder screen when the remote
control unit or extension control unit is connected.
[ON], [OFF]
[MARKER/CHAR LVL] Configures settings for the viewfinder marker and character luminosity.
[50%], [60%], [70%], [80%], [90%], [100%]
[SYNCHRO SCAN Sets the unit in which synchro scan mode is displayed.
DISP]
[sec]
[deg]
[VF MARKER]
Item
[TABLE] Selects the setting table of the marker select function. Check or set the details of
[A]/[B] at subsequent settings.
[A], [B]
[CENTER MARK] Controls the center mark.
[1]
[2]
[3]
[4]
[OFF]
[SAFETY MARK] Selects the type of frame for the safety zone marker.
[1]
[2]
[OFF]
[SAFETY AREA] Sets the size of the safety zone marker.
The constant ratio of length to width can be set in 1% increments.
[80%]...[90%]...[100%]
[FRAME MARK] Selects frame marker [ON]/[OFF].
[ON], [OFF]
Chapter 7 Menu Operations — Menu list
Description of settings
Displays in time.
Displays at shutter open angle.
[ON]
[109%]
[ZEBRA2 DETECT]
[ZEBRA1 DETECT]
[0%]
Description of settings
+ (large)
Open center (large)
+ (small)
Open center (small)
Does not display.
Box
Corners
Does not display.
[ZEBRA2]
[OFF] [SPOT]
– 150 –
Remark
are factory settings.
Remark
are factory settings.