Connecting The <Dc Out> Terminal With The External Recording Start/Stop Switch - Panasonic AJ-PX5000G Operating Instructions Manual

Chapter 5 Preparation — Connecting the <DC OUT> terminal with the external recording start/stop switch
Connecting the <DC OUT> terminal with the external recording start/stop switch
It is possible to retrieve 1.5 A current from the <DC OUT> terminal of the camera.
Recording start/stop can be controlled by connecting an external switch to this terminal.
An LED connected to this terminal can also be used as a tally lamp. This is useful for shooting video when fixing the camera on a crane.
1 GND
2 TALLY OUT
Open collector output on the camera side
Tally lamp on
Tally lamp off
3 Recording start/stop switch
This is connected in parallel to the <REC> button on the camera or the VTR button on the lens.
4 +12 V
@ NOTE
t Make sure that polarity is correct before connecting an external device. Failure to do so may result in a malfunction.
(Connection example)
LED
Resistance
Low impedance
High impedance
<DC OUT> terminal
Cable connector
HR10A-7R-4SC (73)
4 1
Hirose Electric Co.
3 2
Recording
start/stop
– 112 –