Panasonic AJ-PX5000G Operating Instructions Manual page 169

Item
[LIMITER CH1] Selects the channel 1 limiter.
Disabled when automatic adjustment of recording levels is selected.
[ON], [OFF]
[LIMITER CH2] Selects the channel 2 limiter.
Disabled when automatic adjustment of recording levels is selected.
[ON], [OFF]
[LIMITER CH3] Selects the channel 3 limiter.
Disabled when automatic adjustment of recording levels is selected.
[ON], [OFF]
[LIMITER CH4] Selects the channel 4 limiter.
Disabled when automatic adjustment of recording levels is selected.
[ON], [OFF]
[TEST TONE] Selects test signals.
[NORMAL]
[ALWAYS]
[CHSEL]
[OFF]
[FRONT MIC POWER] Sets the phantom power of the front microphone.
[ON], [OFF]
[REAR MIC POWER] Sets the phantom power of the rear microphone.
Phantom power is not output when [OFF] is selected, even if the <REAR AUDIO
CH1> and <REAR AUDIO CH2> switches are set to <+48V>.
[ON], [OFF]
[MONITOR SELECT] Selects the signal method to output to the monitor when the <MONITOR
SELECT> switch is set to <ST> (stereo).
[STEREO], [MIX]
[FRONT MIC LEVEL] Selects the front microphone input level.
[−40dB], [−50dB]
[REAR MIC CH1/3 Selects the rear microphone input level.
LVL] [−50dB], [−60dB]
[REAR MIC CH2/4 Selects the rear microphone input level.
[−50dB], [−60dB]
LVL]
[REAR LINE IN LVL] Selects the rear line input level.
[−3dB], [0dB], [4dB]
[AUDIO OUT LVL] Selects the audio output level.
[−3dB], [0dB], [4dB]
[HEADROOM] Sets the headroom (standard level).
[18dB], [20dB]
[WIRELESS WARN] Sets whether to display a warning when the reception status of the wireless
microphone receiver is poor.
[ON], [OFF]
[WIRELESS TYPE] Selects the type of wireless microphone receiver.
[SINGLE]
[DUAL]
[USB/LAN]
Item
[USB MODE SELECT] Sets the camera operation mode when an external device is connected to the
USB.
[STORAGE]
[DEVICE]
Chapter 7 Menu Operations — Menu list
Description of settings
Outputs test tones to all channels if the <OUTPUT> switch
is <BARS>, and <CH1> on the <AUDIO IN> switch is set to
<FRONT>.
Outputs test tones to all channels at all times when the
<OUTPUT> switch is <BARS>.
Outputs test tones to the channels where <CH1> or <CH2>
on the <AUDIO IN> switch is set to <FRONT> when the
<OUTPUT> switch is set to <BARS>. The test tones are output
to CH3, CH4.
Does not output the test tone.
Selects a single channel type wireless microphone receiver.
Selects a double channel type wireless microphone receiver.
Description of settings
Sets the mode to use to connect an external hard disk drive or
other device.
Selects the USB mode when connecting the camera to a
computer via USB 2.0, and using the P2 card as mass storage.
– 169 –
Remark
are factory settings.
Remark
f This item cannot be changed when [USB MODE]
is set to [ON].
are factory settings.