Panasonic AJ-PX5000G Operating Instructions Manual page 224

Message
[UNKNOWN DATA!]
[USER CLIP NAME MODIFIED!]
[WRITE PROTECTED!]
r Soft keyboard
Message
[AUTHENTICATION ERROR!]
[CANNOT CHANGE!]
[CANNOT SET!]
[INVALID VALUE!]
[CANNOT SET!]
[NO INPUT!]
[CANNOT SET!]
[RETRY PASSWORD IS
DIFFERENT!]
r Storage
Message
[CANNOT ACCESS CARD!]
[CANNOT ACCESS TARGET!]
[CANNOT COPY! FORMAT
STORAGE DEVICE TO FAT]
[CANNOT FORMAT!]
[CANNOT RECOGNIZE
STORAGE DEVICE!]
[CANNOT SELECT! MAX.6
PARTITIONS]
[CARD IS EMPTY! CANNOT
COPY!]
[FORMAT P2 CARD!]
[LACK OF CAPACITY!]
[MISMATCH COMPONENT!]
[STORAGE DEVICE
DISCONNECTED!]
[TOO MANY PARTITIONS!]
[UNKNOWN DEVICE
CONNECTED!]
[VERIFICATION FAILED!]
Chapter 10 Maintenance and Inspection — Warning system
Description
The metadata character code is invalid.
There is a problem with data in the file.
When adding a counter value to the clip name, characters
must be deleted.
The P2 card or SD memory card is write-protected.
Description
Manual authentication failed.
An attempt is made to enter the [PERSON] item (user who
enters the memo) when there is no text memo.
The entered value is invalid.
There is not input to the software keyboard.
The re-entered password is different.
Description
An error occurred while accessing the P2 card.
An error occurred while accessing the connection target.
The partition that can copy clips does not exist on the storage
device.
The storage device cannot be formatted.
The storage device is not correctly recognized.
Storage devices with more than 6 partitions cannot be
selected (mounted simultaneously).
The P2 card to copy is empty.
Cannot import to a P2 card containing clips.
Not enough space left on the storage device.
The P2 card model number of the copy source and copy
destination do not match. Cannot copy.
The connection with the storage device is disconnected.
There are too many partitions.
A non-compatible DVD drive or other device is connected.
The compare check performed after copying failed.
The metadata character code is UTF-8. Enter valid characters
using a viewer.
Create the file again.
For the counter addition setting, the user clip name plus the
counter value can only contain up to 100 bytes. Characters in
the clip name are automatically deleted when the total number
of characters exceeds this limit.
Insert write-accessible media.
Enter the correct password.
Enter the [TEXT] (text information) first.
Change the input value.
Enter the password.
Enter the correct reference password.
Check the P2 card.
Check the storage device status and connection.
Reformat in FAT format, or export the P2 card to create a
partition.
Change the connected storage device.
Reboot the storage device or connect another storage device.
Release selected partitions.
The copy operation is not performed because the card is
empty.
Format the P2 card.
Use a new storage device with sufficient available space or a
formatted storage device.
Use the P2 cards of the same model number, or import on a
clip basis.
Reconnect the USB cable to the <USB3.0> terminal (host).
When it does not function normally after that, turn off the
power once and turn on the power again.
The maximum number of partitions on the storage device is
23. Either reformat, or use a new storage device.
Change the connected device to the correct storage device,
and then turn the power off once and turn it on again.
Copy it again.
– 224 –
Measure
Measure
Measure