Table of Contents
Advertisement
Warning system
When an error is detected right after the unit is turned on or during the operation, the occurrence of the error is notified in the camera image screen of the
LCD monitor or by the tally lamp. Deal with the error by following the indications.
≥ The tally lamp is available when the handle unit (
Cases indicated by error messages
System error
Screen display
Camera image screen
[SYSTEM ERROR]
Warning
Screen display
Camera image screen
[LOW BATTERY]
[HIGH TEMPERATURE]
[FAN STOPPED]
[REC WARNING]
[CARD ERROR <SLOT 1>]/
[CARD ERROR <SLOT 2>]
[END]
(Memory card status display)
(Once every second, flash in red)
Remaining recording capacity display
of the memory card
(Flashes once every second during
recording)
Chapter 10 Notes — Warning system
/
/
CX7
CX8
Description
An error in the standard signal or communication error has
occurred.
Description
Remaining battery level is insufficient.
Displayed when the internal temperature of the main unit
has risen above assumed.
The fan has stopped.
An error of the recording data has occurred during
recording, and the recording has stopped.
It has tried to record exceeding the maximum number of
clips during recording.
A data error caused by the memory card has occurred
during recording or playback.
The remaining recording capacity of the memory card has
exhausted during recording.
Battery is almost consumed.
The remaining recording capacity of the memory card is
getting low.
supplied) is attached.
CX10
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
≥ Press the power button to turn off the power.
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
The power status display becomes
once every second in red.
≥ The power is turned off in approximately 5 seconds.
≥ Replace with a fully charged battery, or connect the AC
adaptor.
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
≥ The power is turned off in approximately 5 seconds.
≥ Turn on the power again and check recording and
playback operations. If the problem persists, consult the
dealer.
≥ The power turns off approximately 1 minute later.
≥ Stop the use immediately when the fan has stopped, and
consult the dealer.
≥ If the fan has stopped, temperature of the unit will rise.
Therefore, do not use the unit for a long period of time.
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
≥ Recording is stopped.
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
≥ Recording is stopped.
≥ [REC WARNING] [<OVER MAX NUM. OF CLIPS>] is
displayed in the warning display field of the STATUS
screen for the mode check.
≥ Replace the memory card or delete unnecessary clips.
≥ When it was recording
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
Recording is stopped.
The memory card where the error has occurred is write
protected after recording stops. Replace the memory card
in the card slot where the error has occurred.
≥ When it was playing back
Playback is stopped.
The tally lamp and all of the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
≥ Recording is stopped.
≥ Replace the memory card or delete unnecessary clips.
Tally lamp flashes once every second.
≥ The current operation will continue.
≥ Replace with a fully charged battery, or connect the AC
adaptor.
≥ Recording will continue.
≥ Replace the memory card as necessary.
- 194 -
Behavior and cause
Behavior and cause
, and it will flash
Advertisement
Table of Contents
