Inspection - Suzuki GSX-R750 Service Manual

INSPECTION

BATTERY CURRENT LEAK INSPECTION
• Remove the front seat. ( 6-8)
• Turn the ignition switch to the OFF position.
• Disconnect the battery
• Connect the multi circuit tester between the
lead wire of the battery.
NOTE:
Leakage is evident if the leading is over 3mA.
[ [
[ 09900-25008: Multi circuit tester set [ [
Battery current leak: Under 3mA
Q Tester knob indication: Current ( Q Q Q Q
#
* Because the current leak might be large, turn the tester
to high range first to avoid tester damage.
* Do not turn the ignition switch to the ON position when
measuring current.
When leakage is found, look for the part where the tester reads
under 3mA through the couplers and connectors by removing
them one by one.
CHARGING OUTPUT INSPECTION
• Remove the front seat. ( 6-8)
• Start the engine and keep it running at 5 000 r/min. with lighting
switch turned ON and dimmer switch turned HI position.
Measure the DC voltage between the battery terminals
with the multi circuit tester. If the tester reads under 13.4 V or over
15.1 V, inspect the generator coil and regulator/rectifier.
NOTE:
When making this test, be sure that the battery is in fully-charged
condition.
[ [ 09900-25008: Multi circuit tester set [ [ [
Charging output (Regulated voltage):
V V V V V Tester knob indication: Voltage (
_
lead wire.
_
terminal and
, 20mA)
13.5 – 15.0 V at 5 000 r/min.
)
_
-
_
+
and
-
ELECTRICAL SYSTEM 7-9
DCmA
Battery
-
Battery
+
DCV