Fuel Pump Control System - Suzuki GSX-R750 Service Manual

Hide thumbs Also See for GSX-R750:

Table of Contents

FUEL PUMP CONTROL SYSTEM

When the ignition switch is turned on, current from the battery flows to the fuel pump motor through the

side-stand relay and the fuel pump relay causing the motor to turn.

Since the ECM has a timer function, the fuel pump motor stops turning in three seconds after the switch has

been turned on.

Thereafter, when the crankshaft is turned by the starter motor or the engine has been started, the engine

revolving signal is input to the ECM. Then, current flows to the fuel pump motor from the battery through the

side-stand relay and the fuel pump relay so that the pump continues to function.

A tip over sensor is provided in the fuel pump control circuit. By this provision, anytime the motorcycle tips

over, the tip over sensor sends a signal to the ECM to turn off power to the fuel pump relay, causing the fuel

pump motor to stop. At the same time, current to the fuel injectors as well as the ignition coil is interrupted,

which then stops the engine.

SIDE-STAND RELAY

FI SYSTEM AND INTAKE AIR SYSTEM 4-13

To Starter button

Table of Contents