Suzuki GSX-R750 Service Manual page 137

• Install the clutch springs.
• Hold the clutch housing using the special tool.
#
Be careful not to damage the clutch housing or clutch
plates.
[ 09920-53740: Clutch sleeve hub holder
• Tighten the clutch spring set bolts to the specified torque.
! Clutch spring set bolt: 10 N . m (1.0 kgf . m, 7.0 lb-ft)
NOTE:
Tighten the clutch spring set bolts diagonally.
CLUTCH COVER
• Apply SUZUKI BOND "1207B" lightly to the mating surfaces at
the parting line between the upper, middle and lower crankcases
as shown.
C 99104-31140: SUZUKI BOND "1207B"
• Install the gasket 1 and the dowel pins.
#
Use the new gasket to prevent oil leakage.
• Install the clutch cover and tighten its bolts to the specified torque.
! Clutch cover bolt: 10 N . m (1.0 kgf . m, 7.0 lb-ft)
NOTE:
* Fit the clamp to the bolt A as shown.
* Fit the gaskets to the bolts B as shown.
CYLINDER HEAD
• Fit the dowel pins and the new cylinder head gasket 1 to the
ENGINE 3-89