6-80 CHASSIS
• Stake the joint pin by turning (approximately 7/8 turn) the pres-
sure bolt "A" 3 with the bar until the pin end diameter becomes
the specified dimension.
Pin end diameter specification D
RK
5.45 – 5.85 mm (0.215–0.230 in)
#
* After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
* Should any abnormal condition be found, reassemble
the chain link using the new joint parts.
• Adjust the drive chain, after connecting it. ( 2-21)