Valve Inspection; Valve Installation; Tire Installation - Suzuki GSX-R750 Service Manual

Hide thumbs Also See for GSX-R750:

Table of Contents

VALVE INSPECTION

Inspect the valve after the tire is removed from the rim. Replace

the valve with a new one if the seal rubber is peeling or has dam-

If the external appearance of the valve shows no abnormal con-

dition, removing of the valve is not necessary.

Inspect the valve core.

If the seal has abnormal deformation, replace the valve with a

Any dust or rust around the valve hole must be cleaned off.

Then install the valve in the rim.

To properly install the valve into the valve hole, apply a special

tire lubricant or neutral soapy liquid to the valve.

Be careful not to damage the lip of valve.

• Apply tire lubricant to the tire bead.

• When installing the tire onto the wheel, observe the following

Do not reuse the valve which has been once removed.

Never use oil, grease or gasoline on the tire bead in place

of tire lubricant.

CHASSIS 6-75

Table of Contents