Suzuki GSX-R750 Service Manual page 350

TURN SIGNAL/SIDE-STAND RELAY
REMOVAL
The turn signal/side-stand relay is composed of the turn signal
relay, and the side-stand relay and diode.
• Remove the turn signal/side-stand relay.
SIDE-STAND RELAY INSPECTION
First check the insulation between D and E terminals with the
tester. Then apply 12V to terminals D and C (+ to D and -
to C) and check the continuity between D and E. If there is no
continuity, replace the turn signal/side-stand relay with a new
one.
[ 09900-25008: Multi circuit tester set [ [ [ [
< < Tester knob indication: Continuity test (> < < <
DIODE INSPECTION
Measure the voltage between the terminals using the multi cir-
cuit tester. Refer to the following table.
[ 09900-25008: Multi circuit tester set [ [ [ [
 Tester knob indication: Diode test (=  
 
NOTE:
If the multi circuit tester reads under 1.4V when the tester probes
are not connected, replace its battery .
> ) > > >
Unit: V
= ) = =
=
ELECTRICAL SYSTEM 7-19